Product Description
Doug Fleenor Design's DMX512 isolators with amplifiers are considered some of the best products available for the distribution of lighting control signals. Isolators are used to eliminate ground loops and to provide protection from electrical storms, mis-connections, and equipment failures. With the exception of our Inline Isolator, all Doug Fleenor Design isolators with amplifiers may be used as line amplifiers to boost the signal from as little as 0.2 volts to full DMX output levels. Portable, rack, and wall mount units are available.
Available connector types: 5 pin XLR, 3 pin XLR, terminal block, RJ-45 (ESTA or Color Kinetics pinout), or mounted in a JBOX enclosure.
Warranty
All DFD products have a Five Year Warranty for mechanical defects. Batteries, mechanical relays, and expendables are not covered under standard warranty.Product Videos
Custom Field
varSpecTab 1
Input Circuit EIA-485 receiver with 120 ohm Termination resistor between +Data and -Data (Units with optional feed through connectors do not have internal termination)
Input Signal 0.2 volts minimum, 12 volts maximum
Output Signal EIA-485 driver
Connectors Gold plated 5 pin Neutrik D-1 Series (3 pin connectors, RJ-45, or terminal blocks optional)
Feed Through A non-isolated feed through connector is optional
Isolation 2500 volt optical coupler, 1500 volt split bobbin transformer
Power Input 100 - 120 volts, 50/60 hertz, 12 watts (208 - 240 volt optional)
Color Top, bottom and sides: Silver hammer tone Front and back: Black
Size 121: 6.5" deep, 1.7" high, 6.5" wide
121D 6.5" deep, 1.7" high, 8.25" wide
121Q 6.5" deep, 1.7" high, 16" wide
121D 6.5" deep, 1.7" high, 8.25" wide
121Q 6.5" deep, 1.7" high, 16" wide
